Bernstein F1-ZSP3D Foot Switch

F1-ZSP3D
Foot switch metal; 1-pedal; pedal: 1 NC/2 NO; DGUV approved enabling foot switch; with PNP additional board and pressure point

Suitable for high requirements in industrial applications. Existing mounting holes offer the possibility of screwing the foot switches to the base. Each foot switch is equipped with four rubber feet to prevent slipping. The foot control is made of thermoPlastic. The enabling footswitch offers two enabling Contacts and one signalling contact and is available both with and without detent. When the pedal is depressed to the pressure point, the two enabling Contacts close. When the pedal is released, the enabling Contacts open again. If the pedal is depressed, i.e. beyond the pressure point, the release Contacts open in a positively driven manner. For the application of an enabling device, the standards DIN EN ISO 12100 and DIN EN 60204-1, among others, must be observed. Dynamic position detection is possible with the signal contact. Alternatively, a static position detection can be realised by means of a PNP output. In this way, it is possible to determine actuating position 1 - the OFF position of the enabling Contacts (actuator is not pressed) - or position 3 - the OFF position of the operating Contacts (actuator is fully pressed) - and make them directly available to the control system. The approved enabling foot switch is only available in the standard version without UN bonnet.